NEC PD78058FY(A) - Manual (Page 135)

135
CHAPTER 6 PORT FUNCTIONS
6.2.4 Port 2 (
µ
PD78058FY Subseries)
Port 2 is an 8-bit input/output port with output latch. P20 to P27 pins can specify the input mode/output mode in
1-bit units with the port mode register 2 (PM2). When P20 to P27 pins are used as input ports, an on-chip pull-up
resistor can be used to them in 8-bit units with a pull-up resistor option register L (PUOL).
Alternate functions include serial interface data input/output, clock input/output, automatic transmit/receive busy
input, and strobe output.
RESET input sets port 2 to input mode.
Figures 6-7 and 6-8 show block diagrams of port 2.
Caution When used as a serial interface pin, set the input/output and output latch according to its
functions. For the setting method, refer to Figure 17-4 Serial Operating Mode Register 0 Format
and Figure 18-3 Serial Operating Mode Register 1 Format.
Figure 6-7. P20, P21, P23 to P26 Block Diagram
PUO : Pull-up resistor option register
PM : Port mode register
RD : Port 2 read signal
WR : Port 2 write signal
P-ch
WR PM
WR PORT
RD
WR PUO
AV
DD
Selector
PUO2
Output Latch
(P20, P21, P23 to P26)
PM20, PM21
PM23 to PM26
Internal bus
Alternate Function
P20/SI1,
P21/SO1,
P23/STB,
P24/BUSY,
P25/SI0/SB0/SDA0,
P26/SO0/SB1/SDA1