NetComm NB504 - Manual (Page 17)

YML864 Rev1 ����4 ��e�� ����e ����4 ��e�� ����e
www.netcomm.com.a� 1
After you complete the above, click Next, the Wireless settings page will appear, shown in figure 4-9.
Figure 4-9 Quick Setup - Wireless settings
In this page, you can configure the following wireless parameters:
• Wireless Radio - Indicates whether the Access Point feature of the router is enabled or disabled. If
disabled, the WLAN LED on the front panel will not be lit and the wireless stations will not be able to
access the router. If enabled, the WLAN LED will be lit up and wireless stations will be able to access the
router.
• SSID - Enter a value of up to 32 characters. The same SSID must be assigned to all wireless devices on
your network. The default SSID is Wireless. This value is case-sensitive. For example, NETCOMM is NOT
the same as Netcomm.
• Region - Select your region from the pull-down list. This field specifies the region where the wireless
function of the router can be used. It may be illegal to use the wireless function of the router in a region
other than one of those specified in this field.
• Channel - The current channel in use. This field determines which operating frequency will be used.
• Mode - Indicates the current mode 54Mbps (802.11g), 11Mbps (802.11b). If you select 54Mbps
(802.11g), it is compatible with 11Mbps (802.11b).
These settings are only for basic wireless parameters, for advanced settings, please refer to Section 5.5:
“Wireless.”
�ote: The change of w���ele�� �ett�ng� won’t take effect �nt�l the ��o�te�� ��eboot�! Yo� can ��eboot �t man�ally. If yo� nee� �n�t���ct�on� a�
to how to �o th��, plea�e ��efe�� to Sect�on �.11.�: “Reboot�ng the Ro�te��”