NetComm NB504 User Manual
Page 39
YML864 Rev1
����4 ��e�� ����e
����4 ��e�� ����e
www.netcomm.com.a�
1.
Enter the appropriate MAC Address into the
MAC Address field. The format of the MAC Address is XX-
XX-XX-XX-XX-XX (X is any hexadecimal digit). For example: 00-0A-EB-B0-00-0B.
2.
Enter a simple description of the wireless station in the
Description field. For example: Wireless station A.
3.
Privilege - Select the privileges for this entry, one of Allow / Deny / 64-bit / 128-bit / 152-bit.
4.
WEP Key - If you select 64-bit, 128-bit or 152-bit in the Privilege field, enter any combination of
hexadecimal digits (0-9, a-f, A-F) in the specified length. For example: 2F34D20BE2.
5.
Status - Select Enabled or Disabled for this entry on the Status pull-down list.
6.
Click the
Save button to save this entry.
To add additional entries, repeat steps 1-6.
�ote: When 64-b�t, o�� 18-b�t, o�� 1�-b�t �� �electe�, WEP Key w�ll be enable�.
To modify or delete an existing entry:
1.
Click the
Modify in the entry you want to modify. If you want to delete the entry, click the Delete.
2.
Modify the information.
3.
Click the
Save button.
Click the
Enable All button to make all entries enabled
Click the
Disabled All button to make all entries disabled.
Click the
Delete All button to delete all entries
Click the
Next button to go to the next page and click the Previous button to return to the previous page.
For example: If you desire that the wireless station A with MAC address 00-0A-EB-00- 07-BE be able to
access the router. The wireless station B with MAC address 00-0A-EB- 00-07-5F not be able to access the
router, and the wireless station C with MAC address 00-0A-EB-00-07-8A be able to access the router when
its WEP key is 2F34D20BE2E 54B326C5476586A, while all other wireless stations cannot access the router,
you should configure the
Wireless MAC Address Filtering list by following these steps:
1.
Click the
Enable button to enable this function.
2.
Select the radio button:
Deny the stations not specified by any enabled entries in the list to access for
Filtering Rules.
3.
Delete all or disable all entries if there are any entries already.
4.
Click the
Add New... button and enter the MAC address 00-0A-EB-00-07-BE in the MAC Address field,
enter wireless station A in the
Description field, select Allow in the Privilege pull-down list and select
Enabled in the Status pull-down list. Click the Save and the Return button.
5.
Click the
Add New... button and enter the MAC address 00-0A-EB-00-07-5F in the MAC Address field,
enter wireless station B in the
Description field, select Deny in the Privilege pull-down list and select
Enabled in the Status pull-down list. Click the Save and the Return button.
6.
Click the
Add New... button and enter the MAC address 00-0A-EB-00-07-8A in the MAC Address field,
enter wireless station C in the
Description field, select 128-bit in the Privilege pull-down list, enter
2F34D20BE2E54B326C5476586A in the
WEP Key field and select Enabled in the Status pull-down list.
Click the
Save and the Return button.
The filtering rules that configured should be similar to the following list: