National Instruments BridgeVIEW - Manual (Page 297)

Chapter 14 Arrays, Clusters, and Graphs
© National Instruments Corporation 14-15 BridgeVIEW User Manual
Thus, you can interpret the lower left preceding example as a command to
generate a 1D array of all elements at column 0 and row 3. You can interpret
the upper right example as a command to generate a 2D array of page 1.
The new, 0
th element is the one closest to the original, as shown in the
preceding illustration.
Activity 14-3. Use the Build Array Function
Your objective is to use the Build Array function to combine elements and
arrays into one bigger array.
Front Panel
1. Create a new front panel, as shown in the following illustration.
2. Place a digital control from the Controls»Numeric palette and label it
scalar 1 . Change its representation to I32 .
3. Copy and paste it to create two other digital controls and label them
scalar 2 and scalar 3 .
4. Create an array of digital controls and label it array 1 . Copy and
paste it and label it array 2 .
5. Expand the arrays and enter the values 1 through 9 in array 1 ,
scalar 1 , scalar 2 , array 2 , and scalar 3 , as shown in the
illustration above.
6. Copy the array and paste it and change it to an indicator. Label it
1D array . Expand it to show nine values.