NETGEAR ProSafe SSL312 - Manual (Page 25)

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
Installing the SSL312 2-7
v1.1, November 2006
• Configure a default route
• Configure Ethernet interface IP addresses
Follow these steps to prepare for installation:
1. Change the administrator account password.
a. On the left side of the browser window, select the Users and Groups link.
b. In the Users table, click on admin.
c. Type your new Password and re-type to Confirm Password.
d. Click Apply.
2. Configure the DNS server IP address.
a. On the left side of the browser window, select the Network link.
b. In the Network menu, click the DNS Settings radio button.
c. Enter at least one DNS server IP address.
d. Click Apply.
3. Configure a default route for Internet access.
a. On the left side of the browser window, select the Network link.
b. In the Network menu, click the Static Routes radio button.
c. Specify the Default Gateway Address.
If you plan a single arm topology, the Default Gateway is your corporate firewall. Specify
that IP address for the ethernet-1 interface.
If you plan a routing topology, the Default Gateway for the ethernet-1 interface is your
Internet Service Provider’s gateway. The Default Gateway for the ethernet-2 interface is
your corporate firewall.
d. Click Apply.
4. Change the Ethernet port IP Addresses.
a. Select the Network link.
b. In the Network menu, click the Interfaces radio button.
c. Enter your chosen Ethernet Port 1 IP Address and Subnet Mask.