NETGEAR ProSafe SSL312 - Manual (Page 26)

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
2-8 Installing the SSL312
v1.1, November 2006
d. If you plan a single arm topology, clear the Enable Routing Mode checkbox. If you plan a
routing topology, check the Enable Routing Mode checkbox and enter your chosen
Ethernet Port 2 IP Address and Subnet Mask.
e. Click Apply. If you changed the IP address for the Ethernet Port to which you are
connected, you will now lose your connection to the SSL VPN Concentrator.
Installing the SSL VPN Concentrator
You are now ready to physically install your SSL VPN Concentrator using the following steps:
1. Turn off the power to the SSL VPN Concentrator and connect it to your network in your
chosen topology.
• For a single arm topology, connect Ethernet Port 1 to your corporate network and leave
Ethernet Port 2 disconnected.
• For a routing topology, connect Ethernet Port 1 to your public network and Ethernet Port 2
to your corporate network.
2. Turn on the power to the SSL VPN Concentrator.
3. From a PC on your corporate network, open a suitable browser and access the SSL VPN
Concentrator web management interface by typing https://[IP_address], where IP_address is
the address that you assigned to the SSL312 Ethernet Port that is connected to the corporate
network.
4. Log in as admin using the new password that you assigned. You can now continue the
configuration of your SSL VPN Concentrator.
Managing Certificates
Establishing an SSL connection requires that the SSL server, such as your SSL VPN Concentrator,
provide a digital SSL certificate to the user’s browser. A certificate is a file that contains:
• A public encryption key to be used for encrypting your messages to the server.
• Information identifying the operator of the server.
• A digital signature confirming the identity of the operator of the server.