NETGEAR ProSafe SSL312 - Manual (Page 91)

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
Additional System Configuration 7-3
v1.1, November 2006
2. Enter the Ethernet Port 1 subnet mask that has been configured for your network. The subnet
mask value should be the same value as the subnet mask configured on your network
computers. The factory default is 255.255.255.0 (The subnet mask specifies the network
number portion of an IP address.).
3. Only if you plan to use two port mode, enable routing mode by checking this checkbox. The
second Ethernet port will be enabled.
4. Enter a local or internal IP address of your ProSafe SSL VPN Concentrator 25. This address
should be in a different subnet than the Ethernet Port 1 IP address. The default Ethernet Port 2
IP Address is 10.0.0.1.
5. Enter the subnet mask. The subnet mask specifies the network number portion of an IP
address. The factory default is 255.255.255.0.
Figure 7-2
Note: NETGEAR recommends one port operation for most networks.