NETGEAR ProSafe SSL312 - Manual (Page 84)

NETGEAR ProSafe SSL VPN Concentrator 25 SSL312 Reference Manual
6-4 Configuring the SSL VPN Tunnel Client and Port Forwarding
v1.1, November 2006
.
Adding Routes for VPN Tunnel Clients
The VPN Tunnel Clients assume that the following networks are located across the VPN over SSL
tunnel:
• The subnet containing the client IP address (PPP interface), as determined by the class of the
address (Class A, B, or C).
• Subnets specified in the Configured Client Routes table.
If the assigned client IP address range is in a different subnet than the corporate network or if the
corporate network has multiple subnets, you must define Client Routes.
To add an SSL VPN Tunnel client route:
1. Access the VPN Tunnel menu.
1. In the Destination Network field under Add Routes for VPN Tunnel Clients section, enter the
network address of a local area network or subnet. For example, enter 192.168.0.0.
2. Enter the subnet mask of the local area network Subnet Mask field.
Figure 6-1