Configuration, Jumper and switch settings – Nortel Networks 1000 User Manual
Page 442
442
NT8D02 and NTDK16 Digital Line cards
Table 181
NT8D02 Digital Line Card - backplane pinouts (cont’d.)
Backplane
Pinout*
Lead
Designations
Backplane
Pinout*
Lead
Designations
68A
Line 14, Ring
68B
Line 14, Tip
69A
Line 15, Ring
69B
Line 15, Tip
*These pinouts apply to both the NT8D37 and NT8D11 backplanes
Configuration
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line card and configuring the system
software to properly recognize the card.
Figure 114 "Digital line card -
jumper block and switch locations" (page 444)
shows where the switches
and jumper blocks are located on this board.
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line Card and configuring the system
software to properly recognize the card.
Figure 115 "Digital line card -
jumper block and switch locations" (page 445)
shows where the switches
and jumper blocks are located on this board.
This section outlines the procedures for configuring the switches and
jumpers on the NT8D02 Digital Line Card and configuring the system
software to properly recognize the card.
Figure 116 "NT8D02 Digital Line
Card - jumper block and switch locations" (page 446)
shows where the
switches and jumper blocks are located on this board.
Jumper and switch settings
The NT8D02 Digital Line card has no user-configurable jumpers or
switches. The card derives its address from its position in the backplane
and reports that information back to the Call Server through the LAN Link
interface.
The NT8D02 Digital Line Card has no user-configurable jumpers or
switches. The card derives its address from its position in the backplane
and reports that information back to the Meridian 1 CP through the LAN
Link interface.
The NT8D02 Digital Line Card has no user-configurable jumpers or
switches. The card derives its address from its position in the backplane
and reports that information back to the Meridian 1 Call Processor through
the LAN Link interface.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311
02.06
Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.