Nortel Networks 1000 - Manual (Page 47)

Operation 47
2 Install the trunk card into the selected slot.
Figure 10
IPE trunk cards installed in an NT8D37 IPE module
3 Install the cable that connects the backplane connector on the
IPE module to the module I/O panel.
4 Connect a 25-pair cable from the module I/O panel connector to
the Main Distribution Frame (MDF).
5 Connect the trunk card output to the selected terminal equipment
at the MDF.
6 Configure the individual trunk interface unit using the Trunk
Administration program (LD 14) and the Trunk Route
Administration program (LD 16).
--End--
Once these steps are complete, the trunk card is ready for use.
Operation
This section describes how trunk cards fit into the CS 1000E, CS 1000M,
and Meridian 1architecture, the buses that carry signals to and from the
trunk cards, and how they connect to terminal equipment. See
Table 7
"Differences between IPE parameters" (page 48) for IPE parameters.
Nortel Communication Server 1000
Circuit Card Reference
NN43001-311 02.06 Standard
27 August 2008
Copyright © 2003-2008 Nortel Networks
.