N-Tron Ntron 7014FX2 - Manual (Page 110)

6/28/2007 page 110 of 145
Get Lock State
Command Name port get lockstate
Description Gets the lock state for a given port.
Syntax port get lockstate <port-no>
Parameters port-no
port number (1 ~ 14).
Examples N-TRON/Admin#[1]> port get lockstate 6
LockState : [enable]
N-TRON/Admin#[2]> port get lockstate 14
LockState : [disable]
NOTES Check whether port-no is in the valid range. (1 ~ 14)
Get Auto-negotiation State
Command Name port get autonego
Description Gets the auto negotiation mode for a given port.
Syntax port get autonego<port-no>
Parameters port-no
Port number (1 ~ 14).
Examples N-TRON/Admin#[1]> port get autonego 6
Auto negotiation mode is : [enabled]
N-TRON/Admin#[2]> port get autonego 12
Auto negotiation mode is : [disabled]
NOTES Check whether port-no is in the valid range. (1 ~ 14)
Set Auto-negotiation State
Command Name port set autonego
Description Sets the auto negotiation mode of a given port to either enable or disable. If
the port auto negotiation mode is enabled, the switch can automatically
adjusts it speed and duplex mode to the incoming speed and duplexmode.
Syntax port set autonego <port-no><enable | disable>
Parameters port-no
port number (1 ~ 12)
enable | disable
Auto negotiation enable or disable
Examples N-TRON/Admin#[1]> port set autonego 6 enable
Auto negotiation mode of port[6] is : [enabled]
N-TRON/Admin#[2]> port set autonego 7 disable
Auto negotiation mode of port[7] is : [disabled]
NOTES Check whether port-no is in the valid range. (1 ~ 12)
Set Priority State
Command Name port set prioritystate
Description Enables or Disables the Priority State on a per port basis.
Syntax port set prioritystate <enable | disable><port-no>
Parameters port-no
port number (1 ~ 14)
enable | disable
Priority State enable or disable
Examples N-TRON/Admin#[1]> port set prioritystate enable 6
NOTES Check whether port-no is in the valid range. (1 ~ 14)