N-Tron Ntron 7014FX2 - Manual (Page 8)

6/28/2007 page 8 of 145
Copyright, © N-Tron Corp., 2007
820 S. University Blvd., Suite 4E
Mobile, AL 36609 USA
All rights reserved. Reproduction, adaptation, or translation without prior written permission from N-Tron Corp. is prohibited, except as allowed
under copyright laws.
Ethernet is a registered trademark of Xerox Corporation. All other product names, company names, logos or other designations mentioned
herein are trademarks of their respective owners.
The information contained in this document is subject to change without notice. N-Tron Corp. makes no warranty of any kind with regard to
this material, including, but not limited to, the implied warranties of merchantability or fitness for a particular purpose. In no event shall N-Tron
Corp. be liable for any incidental, special, indirect, or consequential damages whatsoever included but not limited to lost profits arising out of
errors or omissions in this manual or the information contained herein.
Warning
Do not perform any services on the unit unless qualified to do so. Do not substitute unauthorized parts or make unauthorized modifications to
the unit.
Do not operate the unit with the top cover removed, as this could create a shock or fire hazard.
Do not block the air vents on the sides or the top of the unit.
Do not operate the equipment in the presence of flammable gasses or fumes. Operating electrical equipment in such an environment constitutes
a definite safety hazard.
Do not operate the equipment in a manner not specified by this manual.
Safety Warnings
GENERAL SAFETY
WARNING: If the equipment is used in the manner not specified by N-Tron Corp., the protection provided by the equipment may be
impaired.
LASER SAFETY (FXE Models -40, -80 and optional SFP-LX -40, -70 and -80)
WARNING: CLASS 1 LASER PRODUCT. DO NOT STARE INTO THE LASER..
Contact Information
N-Tron Corp.
820 South University Blvd.
Suite 4E
Mobile, AL 36609
TEL: (251) 342-2164
FAX: (251) 342-6353
WEBSITE: www.n-tron.com
E-MAIL: [email protected]