Trunk related commands – N-Tron Ntron 7014FX2 User Manual

Page 114

Advertising
background image

6/28/2007 page 114 of 145

Clear Counters

Command Name

port clear counters

Description

Clears all the numbers in the counters for a given port. These are counters
for RX bytes and TX bytes and so on.

Syntax

port clear counters <port-no>

Parameters

port-no

port number (1 ~ 14)

Examples

N-TRON/Admin#[1]> port clear counters 6
Counters of Port[6] are : [cleared]

NOTES

This will clear all data in the port specific counters. This data cannot be
recovered after this step.

Clear Intruder Log

Command Name

port clear intruderlog

Description

This command will clear all intruders out of the intruder log.

Syntax

port clear intruderlog

Parameters

None

Examples

N-TRON/Admin#[1]> port clear intruderlog

NOTES

This will clear all data from the intruder log. This data can not be
recovered after this step.



Trunk related commands

Enable or disableTrunking

Command Name

trunk set <enable | disable>

Description

To enable or disable the trunk that is already created.

Syntax

trunk set enable
trunk set disable

Parameters

Enable | disable

Examples

N-TRON/Admin#[1]> trunk set enable
Trunking is activated.
N-TRON/Admin#[1]> trunk set disable
Trunking is deactivated.

NOTES

RSTP must be disabled in order to use Trunking. All trunk ports must be at
the same speed and duplex mode. It is best to hard code speed and duplex
mode for each trunking link, at both ends.
Do not use Trunking on a switch that is directly in an active N-Ring.

Modify Trunk

Command Name

trunk modify

Description

To add new required ports to the trunk in order to withstand high traffic.

Syntax

trunk modify <port-list> [-name <trunk-name>]

Parameters

port-list
Port numbers to be in the trunk.
trunk-name

Name given to a trunk

Examples

N-TRON/Admin#[6]trunk> modify 1,2 -name trunk1

NOTES

A maximum of 4 ports can be in a trunk. All trunk ports must be at the
same speed and duplex mode. If a port is not linked, there could be
difficulty matching similar speed and duplex mode. It is best to hard code
speed and duplex mode for each trunking link, at both ends.

Advertising
This manual is related to the following products: