N-Tron Ntron 7014FX2 User Manual
Page 25
Advertising
6/28/2007 page 25 of 145
Administration – SNMP
The SNMP tab under the administration category shows a list of IP Addresses that act as SNMP Traps. The
Get, Set, and Trap Community Names are also shown here.
By selecting the modify button you will be able to change any of the fields listed. This allows the user to set
an IP address for an SNMP Trap or change the Community Names. Systems that are listed as an SNMP
Trap will be sent basic networking changes made to the switch such as ports going down or being linked.
To restore a Trap to “Value Not Configured”, enter ‘0.0.0.0’.
Advertising