N-Tron Ntron 7014FX2 - Manual (Page 115)

6/28/2007 page 115 of 145
Create Trunk
Command Name trunk create
Description To create a trunk. A trunk is used to get more bandwidth to withstand high
traffic.
Syntax trunk create <port-list> [-name <trunk-name>]
Parameters port-list
Port numbers to be added to the trunk.
trunk-name
Name given to a trunk
Examples N-TRON/Admin#[1]> trunk create 4-7 –name trunk1
NOTES RSTP must be disabled in order to use Trunking. Only 1 trunk can be
created per switch. A maximum of 4 ports can be in a trunk. All trunk
ports must be at the same speed and duplex mode. If a port is not linked,
there could be difficulty matching similar speed and duplex mode. It is best
to hard code speed and duplex mode for each trunking link, at both ends.
Delete Trunk
Command Name trunk delete
Description To delete the trunk .
Syntax trunk delete
Parameters
Examples N-TRON/Admin#[1]> trunk delete
Trunk has been deleted.
NOTES
Show Trunk Information
Command Name trunk show
Description To show all the trunks information.
Syntax trunk show
Parameters None
Examples N-TRON/Admin#[1]> trunk show
------------------------------------------------
| TRUNK NAME | TRUNK PORTS | TRUNK STATE |
------------------------------------------------
| trunk1 | 3-5 | DISABLE |
------------------------------------------------
NOTES