NCT Group NCT 990T User Manual

Page 130

Advertising
background image

14.3

Listing of Global Messages

Error

Code

Message

Description

Canceling and Re-

pairing Method

130

3006

VALUE EXCESS H, D, P

If in tool offset selection (H) or (D) the
number entered under the address exceeds
the range permitted.
The same error occurs in case of value P
of command G10 L(10, 11, 12, 13).

The message is can-
celed by RESET
key.

3007

G43, G44, H

IN G2, G3

If in a block containing circular interpola-
tion (G2, G3) tool length offset is pro-
grammed (G43, G44, H)

The message is can-
celed by RESET
key.

3008

ERRONEOUS G45...G48

If radius compensation code (D) is chang-
ed when using G45...G48 or
the use of code G45...G48 results in con-
flict.

The message is can-
celed by RESET
key.

3009

G45...G48 IN G41, G42

If code G45...G48 is used when G41 or
G42 is switched on.

The message is can-
celed by RESET
key.

3010

PLANE SELECT. IN G41,
G42

If plane selection (G17, G18, or G19) is
programmed in offset mode (G41, G42).

The message is can-
celed by RESET
key.

3011

RADIUS DIFFERENCE

If the difference between the start point
radius and the end point radius of a circu-
lar arc exceeds the value specified in pa-
rameter 1021 RADDIF.

The message is can-
celed by RESET
key.

3012

ERRONEOUS CIRCLE
DEF. R

If in circular interpolation definition (G2,
G3) radius (R) had been specified and the
start point and end point coincide.

The message is can-
celed by RESET
key.

3013

MULTITURN CIRCLE
FAILURE

If at multiturn circle definition (polar
coordinate specification G16 is on) the
polar angle change is
not negative in case of G2 or
not positive in case of G3.

The message is can-
celed by RESET
key.

3014

ERRONEOUS CIRCLE
DEF.

If when programming circular interpola-
tion (G2, G3) neither the radius (R) nor
the center coordinate (I, J, K) is defined,
or
the specification of center coordinates
conflicts with the selected plane (G17: I,
J; G18: I, K; G19: J,K).

The message is can-
celed by RESET
key.

3015

3016

FORBIDDEN ADDRESS

If an address has been referred to in the
program that is forbidden or conflicting in
that situation.

The message is can-
celed by RESET
key.

3017

,C AND ,R IN ONE BLOCK

If chamfering (,C) and corner round (,R)
have been programmed in the same block.

The message is can-
celed by RESET
key.

Advertising
This manual is related to the following products: