NCT Group NCT 990T - Manual (Page 142)

14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
142
3549 RESTORE MODAL FUNC-
TIONS? Y If AUTOMATIC operation is started from
INTD status by means of START, the
control registers STOP status and question
RESTORE MODAL FUNCTIONS? Y is
displayed (Y=yes). By pressing <SHIFT>
key question RESTORE MODAL FUNC-
TIONS? N is displayed (N=no). The mes-
sage can be switched over by the use of
<SHIFT> key. If START is pressed, the
state before suspension is restored (Y), or
not (N) according to the message. The message is can-
celed by RESET
key. INTD state re-
mains.
3550 RESTORE MODAL FUNC-
TIONS? N
4000 MACRO ERROR 000 The following text form is displayed by
specifying the value of macro variable
#3000:
#3000=nnn(ERROR TEXT)
where nnn=0,1,2,...999 and in the
brackets an optional text can be entered.
Number nnn defines the error code.
(Code=4000+nnn) If it has not been filled
out the error code will always be 4000.
If no error text has been given to the vari-
able the text will always be MACRO ER-
ROR nnn, if it has been given, the text in
brackets is displayed. The message is can-
celed by RESET
key.
4001 MACRO ERROR 001
4002 MACRO ERROR 002
... ...
4999 MACRO ERROR 999
5000 MACRO MESSAGE 000 The following text form is displayed by
specifying the value of macro variable
#3006 in part program:
#3006=nnn(MESSAGE TEXT)
where nnn=0,1,2,...999 and in the
brackets an optional text can be entered.
Number nnn defines the message code.
(Code=5000+nnn) If it has not been filled
out the message code will always be 5000.
If no message text has been given to the
variable the text will always be MACRO
MESSAGE nnn, if it has been given, the
text in brackets is displayed. As the effect of the
message the NC reg-
isters STOP state. By
the use of START it
moves on to the next
block. The message
is canceled by RE-
SET key, but if there-
after START is
pressed, as in all
other cases, the mes-
sage is displayed
again.
5001 MACRO MESSAGE 001
5002 MACRO MESSAGE 002
... ...
5999 MACRO MESSAGE 999