NCT Group NCT 990T - Manual (Page 53)

3.6 SETTING Screens
53
The below table contains the codes of the appropriate functions:
Function Code Function Code
General Security Gate Generated
work offsets 15962 open new program 95148
relative position 15962 delete program 95148
tool offsets 15962 edit program 95148
tool pot table 15962 load program 95148
tool life table 15962 save program 95148
timers and counters 7895123 protect program 7895123
PLC table 15962 DNC channel Generated
#100 macro variables 95148 user’s parameters 7895123
#500 macro variables 95148 parameters Generated
run in auto menu 456852 PLC program Generated
run in MDI menu 357159 service operations Generated
Symbol = (cursor) can be moved to the desired data security service within a column by means
of buttons and . If columns are to be switched use buttons , .
If action menu button is pressed the following actions are offered:
Open
1
Close
2 3 4 5 6 7 8 9 0
Open action: If a locked function is to be opened and security key is at disposal move symbol
= (cursor) to the function. Turn the data security key to enable position on the machine
than press Open button.
If no data security key is on the machine move symbol
= to the function to be enabled
than press Open button.
In this case, provided the function to be opened has fix code, message
Code: _ _ _ _ _ _ _ _
appears in the bottom line. After entering the appropriate fix code taken from the above
table the data input can be closed with the help of button and the function is
enabled.
If the function has generated code, the following message is displayed in the bottom
line:
nnnnnnnn code: _ _ _ _ _ _ _ _
where nnn is an eight-digit number. Start Decoder program on PC and enter the digits
seen on control screen. The key code (a 5 digit number) generated by Decoder
program must be entered from numeric keyboard to control. After the appropriate code