NCT Group NCT 990T - Manual (Page 133)

14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
133
3040 G38 NOT IN G0, G1 If vector hold block G38 was programmed
and the interpolation code is not G0 or
G1. The message is can-
celed by RESET
key.
3041 AFTER G2, G3 ILLEG.
BLOCK If in offset mode (G41, G42) an offset
mode cancel block (G10, G20, G21, G22,
G23, G28, G29, G30, G31, G37, G52,
G53, G54, ..., G59, G92) is programmed
after circular interpolation block. The message is can-
celed by RESET
key.
3042 G40 IN G2, G3 If offset mode was going to be canceled in
mode G2 or G3:
G40 G2 X Y R. The message is can-
celed by RESET
key.
3043 G41, G42 IN G2, G3 If start-up of offset mode was going to be
performed in mode G2 or G3:
G40
G41 G2 X Y R. The message is can-
celed by RESET
key.
3044 G41, G42 DEFINITION
ERROR If offset mode is turned on for the duration
of one movement block:
G40...
G41 X Y
G40 X Y. The message is can-
celed by RESET
key.
3045
3046 NO INTERSECTION G41,
G42 If in offset mode (G41, G42) point of
intersection cannot be determined between
the current and next movement block. The message is can-
celed by RESET
key.
3047 CHANGE NOT POSSIBLE If in offset mode (G41, G42) the direction
change (G41 º G42 or G42 º G41) is
not feasible even by relocation of the
circle center. The message is can-
celed by RESET
key.
3048 INTERFERENCE ALARM If in offset mode (G41, G42) interference
alarm occurs. The message is can-
celed by RESET
key.
3049 CIRCLE ARC TOO LONG If the arc of a circle (G2, G3) is too long. The message is can-
celed by RESET
key.
3050 NO REFRNC POINT G29,
G30 If no reference point return has been done
on axes programmed in the block when
executing command G29 or G30. The message is can-
celed by RESET
key.