NCT Group NCT 990T User Manual
Page 27
3.2
CHECK Screens
27
Operation Modes Actions (Modes)
The following modes can be selected:
Edit
1
Auto
2
Mdi
3
Jog
4
Incr
5
Handle
6
Ref
7
8
9
0
Axes Actions
In the menu bar all axes of the machine tool are listed. Here the axis, with which an action
must be done, can be selected. This action is necessary for example if an axis is to be moved by
means of a manual handle. The axis to be moved must be selected by the use of the appropriate
softkey In this case a highlighted frame surrounds the letter
indicating the selected one in the
Axis line of general displaying area.
X
1
Y
2
Z
3
B
4
5
6
7
8
9
0
Increment Actions (Incr)
In the menu bar the eligible increment sizes are listed. If one is selected, it is surrounded by a
highlighted frame. The selected increment has function in the Incremental feed (INCR) and
Manual handle feed (HNDL) modes. The values seen in the menu bar are in increments.
1
1
10
2
100
3
1000
4
5
6
7
8
9
0
% Actions
The rapid traverse, spindle and feedrate switches can be modified by pressing softkeys.
R-
1
R+
2
S-
3
S+
4
F-
5
F+
6
7
8
9
0
The current position of switches can be seen in the middle of general displaying area at
addresses G, S and F.
Conditions Actions
The following states can be switched on or off:
Single
block 1
Cond.
block 2
Cond.
stop
3
Block
return 4
Block
restart 5
Dry run
6
Machin
e lock 7
Test
8
9
0
Machine Actions (Mach)
Maximum eight optionally used softkeys. Their captions are determined by the PLC program,
about their operation and usage instructions can be read in the enclosed manual of the machine.
Provided the :197 module of PLC program does not contain the caption of keys, the PLC1,
PLC2 ... PLC8 is set automatically.