NCT Group NCT 990T - Manual (Page 134)

14.3 Listing of Global Messages
Error
Code
Message Description
Canceling and Re-
pairing Method
134
3051 G22, G28, ... G31, G37 If in block G22 incorrect address is found,
if in block G22 P is not 0 or 1,
if in block G22 relation between the value
of addresses X Y Z and I J K is incorrect,
if in block G22 reference was made to a
non-existing axis,
if in block G28, G29, G30 address differ-
ent from axis address, addresses N, P, F,
M, S, T has been programmed,
if in block G30 P is not 1, 2, 3, 4,
if in block G31address different from axis
address, N and F has been programmed,
if in a block G37 0 displacement has been
programmed or more than one coordinate
has been referred to. The message is can-
celed by RESET
key.
3052 ERROR IN G76, G87 If drilling cycle G86.1 is programmed and
the facility of spindle orientation is not
incorporated, or
if a drilling cycle G87 is programmed, the
spindle can be oriented but cycle is in
state G99. The message is can-
celed by RESET
key.
3053 NO BOTTOM OR R POINT If in the canned cycle R point or bottom
(Z) point has not been defined. The message is can-
celed by RESET
key.
3054 G31 IN INCORRECT
STATE If in block G31
state G16 is on,
if state G41 or G42 is active,
if one of the transformations (G51, G51.1,
G68) is on,
if the state G16 or G95 is active. The message is can-
celed by RESET
key.
3055 G37 IN INCORRECT
STATE If in block G37
state G16 is on,
if length offset G code (G43, G44, G49)
has been programmed,
if one of the transformations (G51, G51.1,
G68) is on. The message is can-
celed by RESET
key.
3056 LIMIT If parameter 3163 CHBFMOVE is set to 1
and the end position of programmed block
exceeds the overtravel limit specified by
parameter. The message is can-
celed by RESET
key.
3057 FORBIDDEN AREA If parameter 3163 CHBFMOVE is set to 1
and the end position of the programmed
block is in the forbidden area specified by
instruction G22. The message is can-
celed by RESET
key.
3058 NOT IN DNC If during DNC machining command M99
P, GOTO or WHILE...DO occur in main
program. The message is can-
celed by RESET
key.