NCT Group NCT 990T - Manual (Page 38)

3.4 OFFSETS Screens
38
3.4.3 WORK OFFSET MEASURE Screen
In the upper part of general
displaying area the current tool
position can be seen. The first
column always shows the
machine position, the middle
column the position in the
selected coordinate system,
while the last one the distance to
go position. The following infor-
mation can be seen in the lower
part of general displaying area
going downwards. In line Nnn
the length offset values of the
indicated offset group can be
seen for each axis. In the next
line stands the number of the se-
lected coordinate system, and below its offset registers. Along the offset registers highlighting
bar can be moved by means of keys and . This highlighting bar enables to select
the offset register to be modified.
Actions of WORK OFFSET MEASURE Screen
The following actions and action menus can be activated to the WORK OFFSET MEASURE
screen by pressing action menu key :
Work
coordnt 1 Ofs No
search 2 /2
3
Single
block 4
5 6 7 8 9 0
Work Coordinate Action Menu: When pressing the key the eligible coordinate systems
appear in the menu bar: G54, G55, ... G59 and Work shift. After pressing the
appropriate softkey the system returns to first level of action menu.
Offset No. Search: When pressing the key letter N appears in spite of the axis address. At this
point the number of offset the register can be entered. After entering the offset number
the desired length offset register can be seen in general displaying area.
/2 Action: It halves value written on the current address letter. During execution half of the
value in the coordinate address can be seen in input field.
Single Block: By pressing the key a single block can be entered in the bottom, data input line
by the use of the alphanumeric keyboard. After closing block edit (key or )
caption SBEX appears in the 2
nd
field of status bar. The block is executed with START
.