Roland XV-5080. - Manual (Page 114)

114
Chapter 3 Selecting Output Jacks
Rhythm Set Mode Settings
Signal (RHYTHM TONE) Flow
fig.03-003.e
Parameters
The parameters related to Patch output settings are shown
below.
RHYTHM Effects General page
([RHYTHM] - [F6 (Effects)] - [F1
(General)])
These parameters set the output destination and level for the
currently selected Rhythm Set Tone, and allow you to set its
send levels to the Chorus and Reverb.
Rhythm Tone Output Assign
Available Settings:
MFX: The Tone is sent to the Multi-effects. Its output
destination is determined by the Multi-effects output
settings.
A–D: The Tone is sent to one of the four output-jack stereo
pairs, OUTPUTS A–D.
1–8: The Tone is sent to the INDIVIDUAL OUTPUT jacks 1–
8.
Rhythm Tone Dry Send Level
Range: 0–127
Sets the level of the signal to be sent to the OUTPUT jacks,
which is determined by Rhythm Tone Output Assign.
Rhythm Tone Chorus Send Level
Range: 0–127
Sets how much of the Tone is sent to the Chorus. Its final
output destination is determined by the Chorus output
setting.
Rhythm Tone Reverb Send Level
Range: 0–127
Sets how much of the Tone is sent to the Reverb. Its final
output destination is determined by the Reverb output
setting.
MFX Dry Send Level
Range: 0–127
Determines the level of the Multi-effects processor’s output
to the OUTPUT jacks.
B
A
C
D
CHO
RHYTHM
TONE
OUTPUT B
OUTPUT C
OUTPUT D
REV
M-FX
Output Assign
M-FX
Output Assign
Chorus
Output Assign
Reverb
Output Assign
OUTPUT A