Roland XV-5080. - Manual (Page 79)

79
Chapter 2 Using the XV-5080 Effects
Chap.2
Step Rate
Switch (Step Rate Switct)
Determines whether the pitch is changed in a stepped
fashion (ON) or not (OFF).
Step Rate (Step Rate) #
And adjust the rate at which the pitch will change.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Balance
Balance #
Adjust the volume balance between the original sound and
the flanger sound.
With a setting of D100:0W only the direct sound will be
output, and with a setting of D0:100W only the flanger sound
will be output.
Output
Output (Output Mode)
Adjust the method that will be used to hear the sound that is
output to the OUTPUT jacks. The optimal 3D effect will be
achieved if you select SPEAKER when using speakers, or
PHONES when using headphones.
Level (Output Level)
Adjust the output level.
62:TREMOLO
Tremolo cyclically modulates the volume to add tremolo
effect to the sound.
fig.2-72
Tremolo
Mod Wave (Modulation Wave)
TRI: The sound will be modulated like a triangle wave.
SQR: The sound will be modulated like a square wave.
SIN: The sound will be modulated like a sine wave.
SAW1/2: The sound will be modulated like a sawtooth wave.
The teeth in SAW1 and SAW2 point at opposite directions.
fig.2-72a
Rate #
Adjust the frequency (speed) of the change.
Depth #
Sets the depth to which the effect is applied.
EQ Gain
Low (Low Gain)
Adjust the low frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
High (High Gain)
Adjust the high frequency gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
Output
Level (Output Level)
Adjust the output level.
63:AUTO PAN
The Auto Pan effect cyclically modulates the stereo location
of the sound.
fig.2-73
Auto Pan
Mod Wave (Modulation Wave)
TRI: The sound will be modulated like a triangle wave.
SQR: The sound will be modulated like a square wave.
SIN: The sound will be modulated like a sine wave.
SAW1/2: The sound will be modulated like a sawtooth wave.
L in
R in
L out
R out
Tremolo
2-Band EQ
2-Band EQ
Tremolo
Saw1 Saw2
L in
R in
L out
R out
Auto Pan
2-Band EQ
2-Band EQ
Auto Pan