Roland XV-5080. - Manual (Page 57)

57
Chapter 2 Using the XV-5080 Effects
Chap.2
Pitch B
Coarse (Coarse Pitch B) #2
Adjust the pitch of Pitch Shift B in semitone steps (-2-+1
octaves).
Fine (Fine Pitch B) #2
Make fine adjustments to the pitch of Pitch Shift B in 2-cent
steps (-100-+100 cents).
One cent is 1/100th of a semitone.
Pan (Output Pan B)
Adjust the stereo location of the Pitch Shift B sound. L64 is
far left, 0 is center, and 63R is far right.
Pre Delay (Pre Delay Time B)
Adjust the time delay from when the direct sound begins
until the Pitch Shift A sound is heard.
Level Balance
Level Balance
Adjust the volume balance between the Pitch Shift A and
Pitch Shift B sounds.
Balance
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
pitch shift sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
pitch shift sound will be output.
Output
Level (Output Level)
Adjust the output level.
23: FBK PITCH SHIFTER
(Feedback Pitch Shifter)
This pitch shifter allows the pitch shifted sound to be fed
back into the effect.
fig.2-29
Pitch
Coarse (Coarse Pitch) #1
Adjust the pitch of the pitch shifted sound in semitone steps
(-2-+1 octaves).
Fine (Fine Pitch) #1
Make fine adjustments to the pitch of the pitch shifted sound
in 2-cent steps (-100-+100 cents).
One cent is 1/100th of a semitone.
Pre Delay (Pre Delay Time)
Adjust the time delay from when the direct sound begins
until the pitch shifted sound is heard.
Mode (Pitch Shifter Mode)
Higher settings of this parameter will result in slower
response, but steadier pitch.
Feedback (Feedback Level) #
Adjust the proportion (%) of the pitch shift sound that is fed
back into the effect. Negative (-) settings will invert the
phase.
EQ Gain
Low (LowGain)
Adjust the gain of the low frequency range.
High (High Gain)
Adjust the gain of the high frequency range.
Balance
Balance (Effect Balance)
Adjust the volume balance between the direct sound and the
pitch shift sound. With a setting of D100:0W only the direct
sound will be output, and with a setting of D0:100W only the
pitch shift sound will be output.
Output
Level (Output Level)
Adjust the output level.
Pan (Output Pan)
Adjust the stereo location of the pitch shifted sound. L64 is
far left, 0 is center, and 63R is far right.
L in
R in
L out
R out
2-Band
EQ
Balance W
Balance W
Balance D
Balance D
2-Band
EQ
Feedback
Pitch Shifter