Roland XV-5080. - Manual (Page 233)

233
Troubleshooting
Appendices
Effects do not apply
Are [MFX], [CHORUS], and [REVERB]
turned off?
• Press the corresponding button to turn on the indicator.
Are the various effect settings correct?
• If the send levels to each effect are at 0, effects will not
apply. Check each setting.
• Even if the send level to each effect is above 0, effects
will not apply if the MFX Output Level, Chorus Level,
and Reverb Level are set to 0. Check each setting.
• If Output Assign is set to PATCH for each Part of the
Performance, the sound will be output according to the
Output Assign settings of the Patch (for each Tone)
which is assigned to those Parts. This means that if the
Output Assign of (each Tone in) the Patch is set to
PATCH, the MFX sound will not be output.
MIDI messages are not
received correctly
Are the receive channel and receive
switch settings correct?
• Check the settings for the MIDI receive channel and the
various switches for reception of MIDI messages.
Are the exclusive receive settings
correct?
• In order for system exclusive messages to be received,
the Device ID Number must match that of the
transmitting device, and the System Exclusive receive
switch must be on. (p. 212) Also, if you wish to rewrite
data in the USER group, the System Exclusive message
Protect Switch must be turned off as well. (p. 205)
Is the DEMO PLAY page displayed?
• When the DEMOPLAY page is displayed, MIDI
messages received from an external device will be
ignored.
Memory Card cannot be
used
Has the Memory Card (SmartMedia)
been initialized?
• An uninitialized Memory Card cannot be used. Perform
the initialize operation. (p. 196)
Are you using a card which the XV-
5080 does not support?
• It is not possible to read the contents of a card which is
for the XV-5080. Also, it is not possible to write data to a
Memory Card which was formatted on a device other
than the XV-5080.
Song data does not
playback correctly
Are you playing back from the middle
of the song?
• The beginning of a GM score song contains a GM System
On message. In some cases, a GM Score cannot be played
back correctly unless this message is received.
Are you playing back GS format song
data?
• Since the XV-5080 is a GM system compatible sound
source, there may be cases in which GS format song data
will not playback correctly.
The SCSI device is not being
recognized.
Could you have turned on the devices
in the wrong order?
• Read “Turning On the Power” in Quick Start (P. 12),
then turn on the power to the devices in the correct
order.
With some SCSI devices, it can take
longer than usual before they are
recognized
• Should this be the case, set a higher value for the SCSI
Probe Time (p. 208).First, turn off the XV-5080’s power,
following the instructions in “Turning Off the Power” in
Quick Start (P. 12). Then, following the instructions in
“Turning On the Power” in Quick Start (P. 12), turn on