Roland XV-5080. - Manual (Page 36)

36
Chapter 2 Using the XV-5080 Effects
Rhythm Set Mode Settings
You can apply Multi-effects, Chorus or Reverb to each of a
Rhythm Set’s Tones. You can control the amount of effect to
be applied to each Rhythm Tone by adjusting its send level to
the Multi-effects, Chorus and Reverb.
fig.02-022.e
The primary role of the effect settings is to determine the
Rhythm Tone Output Assign.
You can select from the following Rhythm Tone Output
Assign settings values to suit your purposes.
MFX: Selected when Multi-effects, chorus, and reverb are
used.
A-D: Selected when outputting in stereo without use of the
Multi-effects. Chorus and reverb can be used.
1-8: Selected when outputting in mono without Multi-
effects. Chorus and reverb can be used. When this setting is
used, chorus and reverb sounds are output in stereo
according to the Chorus Output Assign and Reverb Output
Assign settings.
The screen appears as shown below, according to the settings
values.
• For MFX
fig.02-023.e_70
• For A–D
fig.02-024.e_70
• For 1–8
fig.02-025.e_70
The following shows the basic setting procedure.
1. Select the Rhythm Tone you wish to set.
2. Press [F6 (Effects)].
The Patch Effect page appears.
3. Press [F1 (General)].
The General page will appear.
fig.02-026.e_70
4. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
the parameter you want to set.
5. Turn the VALUE dial or press [INC]/[DEC] to select the
desired value.
* If you make a mistake when setting a parameter’s value, or you
don’t like the change you have made, just press [UNDO] to
restore the value the parameter originally had.
6. Repeat Steps 3 to 5 to set the Effect.
7. Press [EXIT] to return to the RHYTHM Play page.
A “*” symbol will appear at the left of the Rhythm Set name,
indicating that its settings have been modified.
fig.02-027.e_70
* If you turn off the power or select another Rhythm Set while
the “*” symbol is displayed, your new Rhythm Set settings
will be lost. If you wish to keep them, perform the Write
operation. (p. 194)
* When [MFX], [CHO], or [REV] are turned off, effects
processors that are turned off will be indicated by a dashed
outline in the General page.
Chorus
Reverb
RHYTHM
TONE
Multi-Effects
Rhythm Set
B1
D7