Roland XV-5080. - Manual (Page 206)

206
Chapter 8 Saving Tones and Other Data You’ve Created
6. Press [EXIT] several times to return to the applicable
PLAY page.
* Even if the Internal Write Protect setting is “ON” (write
prohibit), incoming System Exclusive messages can rewrite
the User memory data if the Exclusive Protect setting is set to
“OFF” (write permit).
Resetting All Settings to
Default Factory Settings
(Factory)
This function resets all the XV-5080’s settings to their factory
default values.
If the XV-5080 internal memory already contains important
data that you have created, this operation will cause all of
this data to be lost. If you wish to preserve any of its
contents, you must save them on a commercially available
memory card (p. 195) or to an external sequencer (p. 203) or
storage device before performing the Factory Reset.
The following shows the setting procedure.
1. Press [SYSTEM/UTILITY], getting its indicator to start
blinking.
* If the indicator is steadily lit, you are in SYSTEM mode. Press
[SYSTEM/UTILITY] once again, so the indicator is blinking.
2. Press [F6 (Menu)] to select Menu 3.
3. Press [F5 (Factory)].
The Factory Reset page appears.
fig.08-012.e_70
4. Press [F6 (Execute)] to execute Factory Reset.
To cancel the Factory Reset, press [EXIT].
After the Factory Reset operation has been executed, the
PATCH PLAY page will appear.
The message “Write Protect ON” may appear in a window. If
you want to continue with the Factory Reset, press [DEC] to
set Write Protect to “OFF,” and press [F6 (OK)] to close the
window. Then press [F6 (Factory)] once more to execute the
Factory Reset.
Once set to “OFF,” Write Protect remains disabled until the
power to the instrument is turned off.