Roland XV-5080. - Manual (Page 204)

204
Chapter 8 Saving Tones and Other Data You’ve Created
Source
You can specify the data to be transmitted by selecting the
appropriate combination shown below.
For example, if you wish to transmit the USER group Patches
001–020, you would specify “PATCH USER: 001–020.”
TYPE BLOCK
ALL USER
TEMP
PERFORM USER 01–64
TEMP -PATCH *1
+PATCH *2
CTRL
PATCH USER 001–128
TEMP
RHYTHM USER 001–004
TEMP
SYSTEM USER
* 1 The current Performance
* 2 The current Performance and the Patch or Rhythm Set
assigned to each Part of the Performance
* ALL indicates all of the Patches, Performances, and Rhythm
Sets in the following settings (USER or TEMP).
* When set to TEMP, data in the temporary area will be
transmitted.
* When set to CTRL, the status of Performances, including
Performance Bank Selects and Program Changes, are not sent
as Exclusive messages, but rather as MIDI Channel messages.
For more on the transmitted MIDI channel messages, refer to
“MIDI Implementation.” (p. 282)
* It is not possible to transmit GM system settings.
Destination
As shown in the diagram, connect the XV-5080 to the
external MIDI device before performing the procedure.
fig.08-012.e_70
1. Press [SYSTEM/UTILITY], getting its indicator to start
blinking.
* If the indicator is steadily lit, you are in SYSTEM mode. Press
[SYSTEM/UTILITY] once again, so the indicator is blinking.
2. Press [F6 (Menu)] to select Menu 2.
3. Press [F1 (Xfer)].
4. Press [F1 (To MIDI)].
5. Press [ ]/[ ]/[ ]/[ ] to move the cursor to
the parameter you want to set.
6. Turn the VALUE dial or press [INC] / [DEC] to select the
desired value.
7. Press [F6 (Trans)] to execute the transmission.
* To cancel the operation, press [EXIT].
Transmitting to User Memory
You can transmit Patch, Performance or Rhythm Set settings
to the USER memory and System settings to the System
memory.
fig.08-010.e_70
You can specify the data to be transmitted by selecting the
appropriate combination shown below.
For example, if you wish to transmit only the PR-A group
Patch 001, specify “PATCH PR-A: 001–001.”
If the selected data is too large to fit completely into the
transmission destination, as much of the data as will fit will
be transmitted, starting at the first number of the specified
transmission destination.
(Example)
Source
Type: PATCH
Block PR-A:001–005
Destination
User:127
If the above settings are made and transmission is executed,
only the two PR-A group Patches 01 and 02 will be
transmitted to USER group Patches 127 and 128.
XV-5080
Sequencer, etc.
MIDI IN
MIDI OUT