Ricoh AP305 User Manual
Page 102
Troubleshooting
72
6
It takes too much time to per-
form black and white print-
ing.
[Color]
is selected on the printer driver's
[Setup]
tab.
Change this setting to
[Black & White]
. See the printer
driver's online help for details about changing the set-
tings on this tab. Note, however, that some applica-
tions ignore the color mode setting made with the
printer driver.
Paper isn't fed from the de-
sired paper tray.
The printer driver setting is not correct. Change the set-
ting. See the printer driver's online help for further de-
tails.
Desired paper size isn't used
for the output.
The printer driver setting is not correct. Change the set-
ting.See the printer driver's online help for further de-
tails.
Check the paper size settings. The size specified with
the paper size dial might be different from the actual
paper size. Make the correct dial setting.
Specified paper is not loaded correctly in the paper
tray. Remove the paper from the tray and reload the
specified paper correctly.
Printed side gets dirty.
The charger and dust-proofing glass are dirty. Clean
the charger and dust-proofing glass.
the Charger” and P.81 “Cleaning the Dust-proofing glass”
Check the image density setting.
If the message "Change PCU" appears on the panel dis-
play, replace the photoconductor unit.
Image density is too light.
If turning on the
[Toner Saving]
setting on
[Quality Set-
ting]
tab, it can cause blurring or fine lines might not be
printed. With color printing, toner saving can cause ab-
normal coloring. Try printing again after turning
[Toner
Saving]
off. See the printer driver's online help for de-
tails about changing the settings on this tab.
If the message "Add Toner XXX" is on the panel dis-
play, replace the toner cartridge for the indicated color.
P.85 “Replacing the Toner Cartridge”
You might be using paper not supported by this print-
er. Use the appropriate type of paper.
Status
Possible Causes, Descriptions, and Solutions