Ricoh AP305 - Manual (Page 87)

Error & Status Messages
57
6
Paper Size Error There is a difference be-
tween the paper size in the
tray and the requested pa-
per size from the computer. After confirming that the
size, feed direction of paper
and the paper size dial in
the tray are set correctly,
open and close the front
cover.
⇒
P.49 “Loading Pa-
per in the Paper Tray”
Power Off/On
SC:xxx
There is a malfunction in
the printer. Turn the printer off and on.
If this doesn't clear the
problem, contact your sales
or service representative.
Remove Misfeed
From Output Tray
There is a paper misfeed in
the printer. Remove the misfed paper.
⇒
P.76 “Removing Misfed
Paper”
Remove Misfeed
From Tray #
There is a paper misfeed in
the printer. Remove the misfed paper.
⇒
P.76 “Removing Misfed
Paper”
Reset Charger
Correctly
The charger is not set cor-
rectly or the charger clean-
er is not in the correct
position. Set the charger correctly.
⇒
P.92 “Replacing the Waste
Toner Bottle and Charger”
Reset Fusing
Unit Correctly
The fusing unit is not in-
stalled in the printer. Contact your sales or ser-
vice representative.
Reset PCU
Correctly
The photoconductor unit is
not installed in the printer. Install the photoconductor
unit.
⇒
P.88 “Replacing the
Photoconductor Unit”
Reset Toner
Correctly
The toner cartridge is not
installed correctly. Install the cartridge cor-
rectly.
⇒
P.85 “Replacing
the Toner Cartridge”
Reset Tray
Correctly
The paper tray is not in-
stalled correctly. Install the paper tray cor-
rectly.
The tray on the paper feed-
ing path was not set cor-
rectly when the printer
received the print job. Install the paper tray cor-
rectly. The printer will re-
start printing automatical-
ly.
Reset Waste T
Bottle Correctly
The waste toner bottle is
not installed. Install the waste toner bot-
tle.
⇒
P.92 “Replacing the
Waste Toner Bottle and
Charger”
Message Description Comments