Ricoh AP305 - Manual (Page 37)

Turning the Printer On and Off
7
1
Turning the Printer On and Off
Turning On the Printer
A
Make sure that the power cord is
securely plugged into the wall
socket and the printer.
B
Set the printer's power switch to
the On position.
After turning on the printer, it
takes about seven minutes to
warm up before being able to
print. The following message ap-
pears on the operation panel.
IPDL-C
Warming Up
When the printer is turned on, the
Power
indicator will blink repeat-
edly. Once it stops blinking and re-
mains on, you will be able to send
data from the computer to the
printer. When the following mes-
sage appears on the operation pan-
el, the printer will be able to begin
printing.
IPDL-C
Ready
Turning Off the Printer
A
Confirm that the Data In and the
Error indicators are off.
Note
❒ The Data In indicator blinks
while receiving data from the
computer and remains lit when
printing. Do not turn off the
printer while it is receiving data
or printing.
❒ When the Error indicator lights
up, a printer error has occurred.
Use the message that appears
on the operation panel to trou-
bleshoot the problem.
B
Set the printer's power switch to
the Off position.
The Power indicator turns off.
Note
❒ After printing, wait for about
two minutes before turning off
the printer. The printer uses this
time to maintain itself. Turning
off the printer immediately after
printing may, over time, reduce
the print quality.
TFWX130E
TFWX110E