Ricoh AP305 User Manual
Page 104
Troubleshooting
74
6
Changing the color settings
with the printer driver caus-
es a drastic change in print-
out color.
Do not make radical changes in the settings of the
[Col-
or Setting]
tab.
Also note that the sample shown by the printer driver
is intended to show what processes are being applied,
not exactly what your printout will look like. See the
printer driver's online help for details about changing
the settings on this tab.
Photograph printing looks
rough.
Select
[Fine]
on the
[Print Quality]
tab.
Printing from some applications results in a loss of res-
olution.
Color documents are printed
in black and white.
The printer driver is not set up for color printing. Select
[Color]
on the printer driver's
[Setup]
tab. See the printer
driver's online help for details about changing the set-
tings on this tab.
Some applications normally print color text as black
and white. You can obtain correct color printing with
such applications by checking the
[Change data process-
ing]
option in the printer driver's
[Setup]
tab. See the
printer driver's online help for details about changing
the settings on this tab.
Fine dot pattern does not
print.
Select
[Text]
in the
[Dithering]
list box of the
[Color Set-
ting]
tab. See the printer driver's online help for details
about changing the settings on this tab.
Black parts are shiny or
glossy, when created as a
mixture of cyan, magenta,
yellow.
Select
[K]
on the printer driver's
[Graphic Mode]
. See the
printer driver's online help for details about changing
the settings on this tab.
Black gradation is not natu-
ral.
Select
[CMY + K]
on the printer driver's
[Graphic Mode]
.
See the printer driver's online help for details about
changing the settings on this tab.
Thin lines are blurred or
light.
Check
[Print thin lines darker]
box on the printer driver's
[Print Quality]
tab. See the printer driver's online help for
details about changing the settings on this tab.
When printing on OHP
transparencies, a sheet of pa-
per is not placed between
printed OHP transparencies.
The size and direction of the paper loaded in the paper
tray are different from the those of the OHP transpar-
ency. Load the same size and direction paper as the
OHP transparency into the paper tray.
The “OHP Slip” setting is set to “Off” (
Change the setting with operation panel.
Status
Possible Causes, Descriptions, and Solutions