Ricoh LDD280 - Manual (Page 132)

Troubleshooting
120
4
-When a service call message is shown on the display panel
Press [Exit]. Then turn the main switch off and back on again. If a service code
appears again, contact your service representative.
Note
❒ If a service code appears on the display panel after you turn the main switch
off and on a few times, do not continue turning it on and off. Leave the ma-
chine off.
❒ When you make masters continuously using originals with solid images,
“SC203” tends to appear on the display panel. In this case, turn off the main
switch and wait for a while. Then turn on the main switch.
Communication
error has oc-
curred. Turn the
operation switch
off then on.
—
Turn the operation switch off
and on.
If the message appears again,
contact your service representa-
tive.
Print image is
larger than the
selected paper
size. Change pa-
per size.
The master image previously
printed is larger than the paper.
The image exceeds the paper
size. Make prints after pressing [Exit]
and selecting the paper size
again.
Note
❒ If you press [Exit] to erase the
message and press the {Start}
key, the machine starts to
make the prints. However,
the image might not fit on the
paper.
Message Causes Solutions