Olympus C-2100 - Manual (Page 118)

118
RECORDING—Others (Cont.)
Sequential shooting/AF sequential shooting
1 Set the record mode to any mode
other than TIFF. If the record mode
is set to TIFF, the Sequential mode
is not available. (P. 104).
2 Make sure that the mode dial is
switched to P, A, S, M or S-Prg.
3 Press until (sequential
mode) or (AF sequential
mode) is displayed.
4 Press the shutter button to take
pictures.
●
If the battery power runs out during
sequential shooting and the battery
check mark blinks, shooting stops.
Pictures already taken will be
written to the card.
Control panel
Record mode
3
2 4
Control panel
Sequential shooting mode
●
Red-eye reduction mode cannot be set during the sequential mode.
●
When using an external flash, set the speed fast enough to fire for each
shot during sequential shooting.
●
Since the slowest shutter speed in the sequence mode is set to 1/30
second to prevent blurring from camera movement, the resulting picture
may be darker than expected.
●
Unless OFF is selected in All Reset, settings will not be cancelled when the
power is turned off. (P. 148)
Note: