Olympus C-2100 - Manual (Page 72)

72
USING THE FLASH – Auto flash
The flash will work automatically in low-light conditions. For other conditions,
refer to P.107.
1 Slide the flash switch located
under the flash (see the
illustration) to raise the flash.
●
Make sure that , and
do not appear on the control panel.
If there is one or more of them,
press the flash mode button to turn
them off. See SELECT THE
FLASH PATTERN on P.106
2 Press the shutter button halfway.
●
When lights on the viewfinder,
the flash is activated.
●
The flash charges while is
blinking. The shutter cannot be
released at this time. Wait until
turns off before taking pictures.
3 Press the shutter button fully.
●
The flash will go off.
Flash working range:
Wide-angle: approx. 11-13/16" to 13 ft
Telephoto: approx. 3.25 ft to 13 ft
●
The flash will not go off in the following modes: Auto-bracket (P.102),
White/Black Board (P.137), and Panorama (P.135).
●
When using the flash in the macro mode, especially during wide-angle
shooting, images may be unclear and the flash may not have the proper
effect. Confirm the results by displaying images.
Note:
Flash mode button
2, 3
1
P F2.8 1/30 0.0
AF confirmation mark
Flash stand-by