Trimble Outdoors 5700 - Manual (Page 126)

1 0 Default Settings
11 0 5700 GPS Receiver User Guide
Refer
ence
10.1
Introduction
All 5700 receiver settings are stored in application files. The Default
application file, Default.cfg, is stored permanently in the receiver, and
contains the factory default settings for the 5700 receiver. Whenever
the receiver is reset to its factory defaults, the current settings (stored
in the Current application file, Current.cfg) are reset to the values in
the Default application file.
You cannot modify the Default application file. However, if there is a
Power Up application file (Power_Up.cfg) in the receiver, the settings
in this file can be applied immediately after the Default application
file, overriding the factory defaults.
For more information about application files, see Application Files,
page 51.