Trimble Outdoors 5700 - Manual (Page 169)

5700 GPS Receiver User Guide 1 5 3
Troubleshooting 1 4
Refer
ence
Receiver does not log
data. Insufficient memory on the
CompactFlash card. Delete old files using the GPS
Configurator or Trimble Survey
Controller software, or by holding
down
p
for 30 seconds.
No CompactFlash card is
inserted. Insert a CompactFlash card in the
receiver.
The CompactFlash card is
not seated properly. Remove the Compact Flash card
and reinsert it, making sure that it
slides into the housing easily and
seats into the pins.
The receiver is tracking
fewer than four satellites. Wait until the SV Tracking LED is
flashing slowly.
The CompactFlash card is
not formatted, or is
corrupted. Format the CompactFlash card using
the GPS Configurator software, or by
holding down
p
for 30 seconds.
If the problem persists, use the GPS
Configurator software to perform a
full format.
The receiver is not
responding. Receiver needs soft reset. Power down the receiver and power
back up.
Receiver needs full reset. Hold down
p
for 30 seconds.
If you want to retain data files,
remove the CompactFlash card first.
The SV Tracking LED is lit
solidly and the
Logging/Memory LED is
flashing slowly. The receiver is in Monitor
mode, ready for new
firmware to be loaded or
new options to be added. Power the receiver off or on.
Load the latest version of the
firmware, which you can download
from the Trimble web site at
ftp://ftp.trimble.com/pub/survey/bin/
Table 14.1 Troubleshooting (Continued)
Problem Possible cause Solution