Trimble Outdoors 5700 - Manual (Page 159)

5700 GPS Receiver User Guide 1 4 3
Event Marker Input and 1PPS Output 1 3
Refer
ence
To enable event marker input:
1. Connect the computer to the 5700 receiver.
2. Press
p to power on the 5700 receiver.
3. To start the GPS Configurator software, click , then
select Programs / Trimble / GPS Configurator / GPS
Configurator.
The GPS Configurator dialog appears and the software
automatically connects to the 5700 receiver.
4. In the General tab, select the Event marker check box.
5. Select the appropriate option, Positive slope or Negative slope,
depending on the type of pulse the external device uses.
6. Click Apply .
The GPS Configurator software sends the new configuration
information to the 5700 receiver, and the receiver starts to
accept event marker input.
7. Click OK to exit the GPS Configurator software.
The software disconnects from the 5700 receiver.