Trimble Outdoors 5700 - Manual (Page 137)

5700 GPS Receiver User Guide 1 2 1
Cables and Connectors 11
Refer
ence
11.4
Event Marker/1PPS Cable
The event marker/1PPS cable (Part Number 36451-00) shown in
Figure 11.3 provides a breakout box with two BNC (female)
connectors for providing 1PPS input and event marker output.
Connect a device that accepts 1PPS output pulses to the BNC
connector labeled 1PPS on the breakout box. Connect a device that
outputs event marker pulses to the 5700 receiver, such as a
photogrammetric camera, to the BNC connector labeled Event Marker
on the breakout box.
Figure 11.3 Event marker/1PPS cable
In addition, the breakout box includes a Lemo 7-pin connector to
extend serial communications and/or power on Port 2. Because the
BNC connectors are used to service the event marker and 1PPS
features, pins 4 (1PPS) and 5 (Event Marker) are inactive on the Lemo
connector.
P4
P3
P1
P2
(Event marker)
(1PPS out)
(To Port 2)
(Port 2 extension)