Toshiba RAS-13UAV-E2 - Manual (Page 36)

FILE NO. SVM-03008
– 35 –
•
In the illustration, all indications are indicated for explanation.
During operation, only the relevant indications will be indicated on the remote control.
8-6-2. Names and functions of indications on
remote control
[Display]
All indications, except for clock time indication, are
indicated by pushing the START/STOP button.
1 1 1 1 1 Transmission mark
This transmission mark
, indicates when the
remote controller transmits signals to the indoor
unit.
2 2 2 2 2 Mode display
Indicates the current operation mode.
(AUTO : Automatic control, A : Auto changeover
control, : Cool, : Dry, : Heat, : Fan only)
3 3 3 3 3 Temperature display
Indicates the temperature setting (17 C to 30 C).
When you set the operating mode to : Fan only,
no temperature setting is indicated.
4 4 4 4 4 Louver operation display
Indicates the louver positioning and operation.
Five selectable positions
, , , , Automatic
Swing
5 5 5 5 5 FAN speed display
Indicates the selected fan speed. AUTO or one of
five fan speed levels (LOW , LOW
+ ,
MED , MED + , HIGH ) can
be indicated.
Indicates AUTO when the operating mode is either
AUTO or : Dry.
6 6 6 6 6 TIMER and clock time display
The time set for timer operation or clock time is
indicated.
The present time is always indicated except for
TIMER operation.
7 7 7 7 7 Hi-POWER display
Indicates when the Hi-POWER operation starts.
Push the Hi-POWER button to start and push it
again to stop the operation.
8 8 8 8 8 (MEMORY) display
Flashes for 4 seconds when the MEMO button is
pushed during operation.
mark is indicated when keeping the button
depressed for more than 4 seconds while the
mark is flashing.
Push another button to turn off the mark.
9 9 9 9 9 ECO TIMER display
Indicates when the ECO TIMER is in operation.
Each time you push the ECO button, the display
changes in the sequence of 1,3,5 or 9h.
1 3 2 8
9 6 7 5
A
B
AUTOA
4
A
B
A