ZyXEL Communications 202H - Manual (Page 198)

Prestige 202H User’s Guide
18-14 Filter Configuration
18.3.2 Generic Filter Rule
This section shows you how to configure a generic filter rule. The purpose of generic rules is to allow you
to filter non-IP packets. For IP, it is generally easier to use the IP rules directly.
For generic rules, the Prestige treats a packet as a byte stream as opposed to an IP packet. You specify the
portion of the packet to check with the Offset (from 0) and the Length fields, both in bytes. The Prestige
applies the Mask (bit-wise ANDing) to the data portion before comparing the result against the Value to
determine a match. The Mask and Value fields are specified in hexadecimal digits. Note that it takes two
hexadecimal digits to represent a byte, so if the length is 4, the value in either field will take 8 digits, for
example, FFFFFFFF.
To configure a generic rule select an empty filter set in menu 21.1, for example 8. Select Generic Filter
Rule in the Filter Type field and press [ENTER] to open Menu 21.1.x.x
– Generic Filter Rule. The
following example screen shows menu 21.1.8.1.
Figure 18-11 Menu 21.1.5.1 Generic Filter Rule
Table 18-4 Menu 21.1.5.1 Generic Filter Rule
FIELD DESCRIPTION EXAMPLE
Filter # This is the filter set, filter rule coordinates, for instance, 2, 3 refers to the
second filter set and the third rule of that set. 5,1
Menu 21.1.8.1 - Generic Filter Rule
Filter #: 5,1
Filter Type= Generic Filter Rule
Active= No
Offset= 0
Length= 0
Mask= N/A
Value= N/A
More= No Log= None
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Press Space Bar to Toggle.