ZyXEL Communications 202H - Manual (Page 84)

Prestige 202H User’s Guide
8-12 Remote Node Configuration
Menu 11.3 - Remote Node Network Layer Options
Rem IP Addr:
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= None
Address Mapping Set= Full Feature
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Press ENTER to Confirm or ESC to Cancel:
Table 8-5 Remote Node Network Layer Options
Table 8-6 Remote Node Network Layer Options
FIELD DESCRIPTION EXAMPLE
Rem IP Addr This will show the IP address you entered for this remote node
in the previous menu.
Rem Subnet Mask Enter the subnet mask for the remote network.
My WAN Addr Some implementations, especially the UNIX derivatives,
require the ISDN link to have a separate IP network number
from the LAN and each end must have a unique address within
the WAN network number. If this is the case, enter the IP
address assigned to the ISDN port of your Prestige.
NOTE: This is the address assigned to your local Prestige
WAN, not the remote router. If the remote router is a Prestige,
then this entry determines the local Prestige Rem IP Addr in
Menu 11.1.
NAT
Address Mapping
Set
Choose from None, Full Feature, or SUA Only. When you
select Full Feature you must configure at least one address
mapping set!
For more information about NAT and the choices listed refer to
the NAT Chapter.
A NAT Server Set is a list of LAN side servers mapped to
external ports (similar to the old SUA Menu 15.1 before). You
may enter any server set number up to 10 but the first one is
used for SUA only.
Full Feature