ZyXEL Communications 202H - Manual (Page 233)

Prestige 202H User’s Guide
Firmware and Configuration File Maintenance 21-9
Step 8. Enter “quit” to exit the ftp prompt. The Prestige will automatically restart after a successful
restore process.
21.3.2 Restore Using FTP Session Example
Figure 21-8 Restore Using FTP Session Example
Refer to section 21.2.5 to read about configurations that disallow TFTP and FTP from the WAN.
21.3.3 Restore Via Console Port
Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1. Display menu 24.6 and enter “y” at the following screen.
Figure 21-9 System Maintenance: Restore Configuration
Step 2. The following screen indicates that the Xmodem download has started.
Figure 21-10 System Maintenance: Starting Xmodem Download Screen
Step 3. Run the HyperTerminal program by clicking Transfer, then Send File as shown in the
following screen.
ftp> put config.rom rom-0
200 Port command okay
150 Opening data connection for STOR rom-0
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec.
ftp>quit
Ready to restore Configuration via Xmodem.
Do you want to continue (y/n):
Starting XMODEM download (CRC mode) ...
CCCCCCCCC