ZyXEL Communications 202H - Manual (Page 90)

Prestige 202H User’s Guide
9-2 Remote Node TCP/IP Configuration
To configure an IP static route, use Menu 12 – IP Static Route Setup, as displayed next.
Figure 9-2 Menu 12 IP Static Route Setup
From Menu 12, select one of the available IP static routes to open Menu 12.1 – Edit IP Static Route, as
shown next.
Figure 9-3 Menu 12.1 Edit IP Static Route
Table 9-1 Menu 12.1 Edit IP Static Route
FIELD DESCRIPTION
Route Name Enter a descriptive name for this route. This is for identification purposes only.
Active This field allows you to activate/deactivate this static route.
Destination IP
Address This parameter specifies the IP network address of the final destination. Routing is
always based on network number. If you need to specify a route to a single host, use a
subnet mask of 255.255.255.255 in the subnet mask field to force the network number
to be identical to the host ID.
Menu 12 - IP Static Route Setup
1. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter selection number:
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= RouteName
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel: