ZyXEL Communications 202H - Manual (Page 95)

Prestige 202H User’s Guide
Dial-in Setup 10-3
Table 10-2 Menu 13 Default Dial-in Setup
FIELD DESCRIPTION EXAMPLE
Recv Authen This field sets the authentication protocol for incoming calls. For
security reason, setting authentication to None is strongly
discouraged. Options for this field are:
CHAP/PAP – Your Prestige will try CHAP first, but PAP will be
used if CHAP is not available.
CHAP – Use CHAP only.
PAP – Use PAP only.
None – Your Prestige tries to acquire CHAP/PAP first, but no
authentication is required if CHAP/PAP is not available.
CHAP/PAP
Compression Turn on/off Stac Compression. The default for this field is No. Yes
Mutual Authen Some vendors, e.g., Cisco, require mutual authentication, i.e.,
the node that initiates the call will request a user name and
password from the far end that it is dialing to. If the remote node
requires mutual authentication, set this field to Yes.
No
O/G Username Enter the login name to be used to respond to the peer’s
authentication request.
O/G Password Enter the outgoing password to be used to respond to the peer’s
authentication request.
Multiple Link Options:
Max Trans Rate(Kbps) Enter the maximum data transfer rate between your Prestige and
the remote dial-in user. 64 – At most, one B channel is used. 128
– A maximum of two channels can be used. When the Prestige
calls back to the remote dial-in user, the maximum data transfer
rate is always 64.
128
Callback Budget Management:
Allocated Budget
(min)
This field sets the budget callback time for all the remote dial-in
users. The default for this field is 0 for no budget control. 0 (default)
Period (hr) This field sets the time interval to reset the above callback
budget control.
IP Address Supplied By: