ZyXEL Communications omni.net Plus - Manual (Page 145)

Technical Reference for ZyXEL omni.net series
A-11
HDLC Transmit Under-run : 0
Refer to the following table for a description of the Output Parameters of the Link Status Report.
Link Status Report (ATI3) Output Parameters
Output Parameter Output Value Description
Connect DTE Speed Current on-line DTE speed.
Error Control Level Error control protocol used for current session.
Protocol Link Speed Current on-line DCE speed, line speed.
Octets Received Number of data octets received from remote.
Octets Sent Number of data octets sent to remote.
Cause Verbose disconnection reason for the last session.
Cause Value Numerical disconnection reason for the last session.
HDLC FCS Error Errors in frame (block) checksum.
(If there are many FCS Errors, you may be experiencing problems on the line.)
HDLC Transmit Under-run For TA's processor power measurement.
HDLC Receive Over-run For TA's processor power measurement.
Table 69. Link Status Report (ATI3) Output Parameters