ZyXEL Communications omni.net Plus - Manual (Page 148)

Technical Reference for ZyXEL omni.net series
A-14
All the Following Commands Require a 'AT' Prefix
AT Com. Options Function & Description Reference
&V1-4 View the (n-1)th user profile settings (n=1-4).
&V5 View factory-set default settings.
&V6 View POTS port, Phone 1 setting.
&V7 View POTS port, Phone 2 setting.
&Wn n=0-3 Write current settings to user profile 'n' in NVRAM.
(See also S35b6)
&Z? Display all the phone numbers stored in NVRAM.
&Zn=s n=0-39 Write phone number 's' to NVRAM at location 'n' (n=0-39).
Use AT*Dn or ATS29=n to set the default dial pointer.
&ZIn=s n=0-7
s=phone
number
Assign the phone number (including subaddress, if any) for
various B-channel protocols. In answer mode, these numbers
will be compared with the received called_party_number and
called_party_subaddress information. The call will be accepted
using the specific protocol if the assigned number of this protocol
matches with the called_party_number.
&ZI0=s Assign the phone number for X.75.
&ZI1=s Assign the phone number for V.110.
&ZI2=s Assign the phone number for V.120.
&ZI3=s Assign the phone number for PPP, PPP/MP.
&ZI4=s Assign the phone number for ISDN data.
(Multi-Auto Answering, auto detect the protocols.)
&ZI6=s Assign the phone number for POTS port, Phone 2 and modem.
&ZI7=s Assign the phone number for POTS port, Phone 1.
&ZI? Display the phone number (including subaddress, if any) for
various B-channel protocols.
&ZFn=s n=0-4
s=0-63
For USA NI-1 switch only, assign the relative ISDN Ordering
Code, IOC (or dial access code) for each supplementary
service.
&ZF0=s Assign the IOC for Conference.
&ZF1=s Assign the IOC for Drop.
&ZF2=s Assign the IOC for Transfer.