ZyXEL Communications omni.net Plus - Manual (Page 91)

Technical Reference for ZyXEL omni.net series
8-3
V.110 Outgoing Protocol
Use the following commands to configure V.110 outgoing calls.
AT Command Description
ATB10 User rate follows DTE speed (see note below).
ATB13 User rate = 2400bps
ATB14 User rate = 4800bps
ATB15 User rate = 9600bps
ATB16 User rate = 14400bps
ATB17 User rate = 19200bps
ATB18 User rate = 38400bps
ATB19 User rate = 57600bps (For Japanese version only)
The highest Async V.110 user rate depends on bit 4 of [S119]. If the DTE speed is higher than the user setting,
the user rate on the table below will be used.
S119 bit 4 Setting Highest Async V.110 User Rate
S119.4=0 19200 bps
S119.4=1 38400 bps for areas other than Japan (default).
S119.4=1 57600 bps for Japanese version only.
Table 44. V.110 Outgoing Protocol