ZyXEL Communications omni.net Plus - Manual (Page 162)

Technical Reference for ZyXEL omni.net series
B-10
All the Following Commands Require a 'AT' Prefix
S Com. bit dec hex Function and description +Def./Ref.
S41= bit dec hex Bit mapped register +000
3 8 8 Enable CCITT signals 140 and 141 on EIA-232D interface.
5 32 20 DSR follows DCD and pulses (see S44b4). &Sn
6 64 40 Force S0>=2. S0
S42= bit dec hex Bit mapped register +000
3 8 8 Disable escape sequence code in answer mode.
6 64 40 Disable <RINGING> result code. Xn
7 128 80 DCD forced on, but pulse off for 0.5 seconds at carrier loss. &C0
S44= bit dec hex Bit mapped register +000
3 8 8 'ATDSn' initiates auto-dial of the stored numbers
consecutively until connection is made. &Zn
S38b0
4 16 10 DSR follows DTR (see also S41b5). &Sn
S50= 0-25
5
Inactivity timer for RS 232 port.
This timer counts when there is no data flow in or out of the
RS 232 serial port; omni.net will hang up , when timed out.
Units is 10 seconds.
'000' disables timer.
+000
S56= 0-25
5
0-FF Hook flash detected time for POTS port adapter, in units of
10ms.
Default setting 50 = 0.5 seconds.
+050
S57= fax Class
S61= bit dec hex
3 0 (*) 0 MP data sent in rotate mode.
1 1 MP data sent in split mode.
S64= dec hex +005
0-25
5 0-FF Security callback timer in unit of 1 second.
S78= bit dec hex Bit mapped register
0 0 (*) 0 Can get busy tone from Phone 1.